Sand factory is one of the most important materials in the construction and road building industries, we will need sand extracted or produced in the sand factory for almost all construction projects. Some of these materials exist naturally in nature and most of them are produced in factories. If large stones are exposed to rain or wind, they become small pieces and lose their original state, these small pieces are called sandstone. The sand itself has differences in terms of size and structure.
I am important
Concrete production: More than 75% of concrete products are made of sand. Road infrastructure: They use sand and other gravels to strengthen the road and put them with a special combination in the bottom layer of the road to increase the resistance of the road against the weight of the cars. Asphalt: 90% of asphalt particles are sand and only 10% are allocated to other materials such as bitumen. Brick production: Sand is used to produce sand-lime bricks. Construction: All small and large buildings are built with sand and sand is used as mortar in brick buildings. Embankment: One of the important uses of sand is to use it as an embankment; For example, they use sand to build earthen dams.
I saw Andzi Karshah and Saca
Sand production needs different equipment and you should be able to put different types of stone crushers and peripheral equipment in your production line. The most widely used devices in sand production lines are: Jaw crusher: The first crusher that is seen in mineral processing lines is the jaw crusher. This stone crusher has the ability to crush all kinds of stones and turns even very hard stones into small pieces. The crushing operation inside this crusher is done by two fixed and movable jaws. Impact crusher: One of the most widely used equipment in sand production lines is the impact crusher or qubit, which can turn a large amount of incoming stones into sand every hour. Crushing of stones inside this crusher is done by hammers. Minerals enter the device through the opening and collide with a rotor. Several rows of hammers are installed on the rotor, and by hitting the stones, it sends them towards the anvil; There are straps inside the anvil that make the stones smaller. Cone crusher: For stones with high degree of hardness, cone crusher is used, which is very popular due to its high production capacity and long life. Cone crusher is used in the second stage of mineral stone processing production line. Serand: For sand grading, they use a device called Serand, which is available for purchase with different capacities and classes. With the help of sand, all the impurities can be separated from the sand and then the pure sand can be granulated based on the size of the particles.